nRF24L01 + CC1101 RF 2-in-1 Development Board for Flipper Zero, Ultra-Compact 2.4GHz & 433MHz, High Performance, Auto-Switch (mit 3D-gedrucktem Gehäuse) RF Lab App-Ready White
Product Overview
- [PINGEQUA RF Lab App — Zero Config] Works out of the box with the free PINGEQUA RF Lab companion app (open-source, GitHub). No manual setup required. For other GPIO apps, set NRF24 SPI to Extra 7 once — done.
- [2-in-1 Dual-Band Module] Combines 2.4 GHz (nRF24L01+) and Sub-GHz CC1101 (433 MHz) on a single 3.5 × 2 cm PCB. One board replaces two separate modules.
- [Auto Chip-Select — No Bus Conflicts] Independent hardware chip-select (Pin 4 / Extra 7) keeps both chips stable on the same SPI bus simultaneously. No jumpers, no switches.
- [Compact & Ready to Use] Pre-assembled in a Crystal Frost translucent enclosure with two matched antennas included. Plugs directly into Flipper Zero GPIO header.
- [For Developers & Learners] Designed for IoT prototyping, GPIO experimentation, and embedded systems learning. Host device not included.